3 L4-2.5L (2010)
Backup Lamp Switch: Service and Repair
Back-Up Light Switch Removal/Installation [A26M-R]
BACK-UP LIGHT SWITCH REMOVAL/INSTALLATION [A26M-R]
1. Disconnect the negative battery cable.
2. Disconnect the back-up light switch connector.
3. Remove the aerodynamic under cover No.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
4. Remove the back-up light switch.
5. Install the back-up light switch to the transaxle case.
Tightening torque
-
29-52 Nm {2.9-5.3 kgf-m, 21-38 ft-lbf}
6. Install the aerodynamic under cover No.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
7. Connect the negative battery cable.