3 L4-2.5L (2010)
Transmission Position Switch/Sensor: Service and Repair
TRANSAXLE RANGE (TR) SWITCH REMOVAL/INSTALLATION [FS5A-EL]
CAUTION:
-
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
1. Select the selector lever to N position.
2. Perform the following procedures.
a. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the air cleaner component. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Inspect the TR switch. See: Testing and Inspection
Manual Shaft Nut Removal Note
1. Set the adjustable wrench as shown to hold the manual shaft lever and loosen the manual shaft nut.