3 L4-2.5L (2010)
Transmission Speed Sensor: Service and Repair
Input/Turbine Speed Sensor Removal/Installation - FS5A-EL
INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FS5A-EL]
CAUTION:
-
Always use a new bolt. If the removed input/turbine speed sensor installation bolt is reused, it may cause oil leakage.
-
A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent oil leakage from the installation bolt hole which passes
through the component.
1. Perform the following procedures.
a. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the air cleaner component. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.