3 L4-2.5L (2010)
Some harnesses may be routed very close to the starter housing which could make the following procedures difficult to perform. Refer to PROCEDURE
"D" - INCREASING WORK SPACE.
1. Note the area of harness at the engine starter housing contact point (A) to be waterproofed as shown (B).
2. Apply butyl tape in this area by following these steps.
- a. Remove the backing paper of one side of the butyl tape (PN 0000-99-TAPE).
- b. Apply butyl tape to contact area of the emission harness.
- c. Remove the remaining paper backing of the butyl tape.