3 L4-2.5L (2010)
Control Arm: Service and Repair
Rear Suspension - Upper Arm Removal/Installation
REAR UPPER ARM REMOVAL/INSTALLATION
1. When working on the right side of the vehicle, disconnect the canister vent (CV) solenoid valve from the rear crossmember.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the wheel alignment and adjust it if necessary. See: Alignment/Service and Repair/Rear Wheel Alignment
Rear Upper Arm Removal Note
1. Rotate the rear stabilizer component downwards as shown in the figure.
