3 L4-2.5L (2010)
-
If there is any malfunction, inspect the coupler component for continuity.
-
If coupler component has no malfunction, perform the "Off-vehicle inspection".
Solenoid valve specification
Operating inspection
CAUTION:
-
Do not apply battery position voltage to terminals for more than 3 s.
NOTE:
-
Because the operation sound of the solenoid valve is small, perform inspection in a quiet place.
1. Perform the following procedures.
a. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the battery component (ex: battery, battery tray and PCM component). See: Starting and Charging/Battery/Service and
Repair/Removal and Replacement
d. Disconnect the coupler component connector.
2. Apply battery positive voltage to the coupler component terminals A, B and battery negative voltage to GND, and verify that operating sound is
heard from solenoid valve.
-
If the operation sound is not heard, inspect the coupler component for continuity.
-
If coupler component has no malfunction, perform the "Off-vehicle inspection".
Off-Vehicle inspection
1. Measure the resistance between the solenoid valve terminals.
-
If there is any malfunction, replace the solenoid valve. See: Pressure Regulating Solenoid/Service and Repair