3 L4-2.5L (2010)
Pressure Regulating Solenoid: Service and Repair
SOLENOID VALVE REMOVAL/INSTALLATION [FS5A-EL]
WARNING:
-
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.
Primary Control Valve Body
1. Remove the primary control valve body.
a. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the aerodynamic under cover NO.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
d. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.
e. Drain the ATF. See: Service and Repair/Procedures
f.
Remove the oil pan. See: Valve Body/Service and Repair/Removal and Replacement/Control Valve Body Removal/Installation - FS5A-EL
g. Remove the primary control valve body. See: Valve Body/Service and Repair/Removal and Replacement/Control Valve Body
Removal/Installation - FS5A-EL
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Add ATF. See: Service and Repair/Procedures
5. Perform the "Mechanical System Test". See: Transmission Control Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Mechanical System Test [FS5A-EL]
6. Perform the "Road Test". See: Transmission Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Road Test
[FS5A-EL]
