3 L4-2.5L (2010)
10. Add the ATF. See: Service and Repair/Procedures
11. Perform the "Mechanical System Test". See: Transmission Control Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Mechanical System Test [FS5A-EL]
Oil Hose Installation Note
NOTE:
-
If reusing the hose, install the new hose clamp exactly on the mark left by the previous hose clamp. Then apply force to the hose clamp in the
direction of the arrow in order to fit the clamp in place.
1. Align the marks, and slide the oil hose onto the oil pipe until it is fully seated as shown.
2. Install the hose clamp.
3. Install the hose clamp onto the hose.
4. Verify that the hose clamp does not interfere with any other components.
Type B
1. Remove the battery cover. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
2. Disconnect the negative battery cable.
3. Remove the air cleaner component. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair
4. Remove the aerodynamic under cover NO.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
5. Remove the front splash shield (LH). See: Body and Frame/Splash Guard/Service and Repair/Splash Shield Removal/Installation
6. Remove the front mudguard (LH). See: Body and Frame/Spoilers, Flaps, and Air Dams/Mud Flap/Service and Repair
7. Drain the ATF. See: Service and Repair/Procedures
8. Drain the engine coolant. See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
9. Remove in the order indicated in the table.
