3 L4-2.5L (2010)
Clutch Pipe and Clutch Reserve Hose Installation Note
NOTE:
-
A seal ring has been installed to the mid-connector between the clutch master cylinder and clutch release cylinder. Verify that a seal ring is
installed to the clutch pipe when connecting the mid-connector.
-
The O-ring type mid-connector seal ring is installed to the groove at the end of the clutch pipe.
1. Verify that the seal ring is assembled to the clutch pipe so that the ends of the seal ring and the clutch pipe overlap each other.
CAUTION:
-
Verify that there is no chipping or damage to the seal ring of the clutch pipe connector.
2. Return the clutch master cylinder clip to the position shown in the figure.
3. Insert the clutch pipe connector straight.
4. Pull the clutch pipe to verify that it does not come off, and reinsert it completely.
5. Insert the reserve hose connector straight until a click is heard.
6. Pull the reserve hose to verify that it does not come off, and reinsert it completely.
