3 L4-2.5L (2010)
4. Inspect for oil leakage from the crankshaft rear oil seal.
-
If there is any malfunction, replace the crankshaft rear oil seal. See: Engine, Cooling and Exhaust/Engine/Seals and Gaskets/Crankshaft Main
Bearing Seal/Service and Repair
Flywheel Installation Note
1. Install the flywheel to the crankshaft.
2. Clean the crankshaft thread holes before installing the new lock bolts.
3. Hand-tighten the flywheel lock bolts.
4. Install the SST to the flywheel.
5. Gradually tighten the flywheel lock bolts in a crisscross pattern.
Tightening torque
-
108-116 Nm {11.1-11.8 kgf-m, 80-85 ft-lbf}
Pilot Bearing Installation Note
1. Install the pilot bearing using the Snap-on brand millimeter size bushing driver set (A160M) adapter A160M7 (20-22 mm).
CAUTION:
-
Use the adapter with the 20 mm side of the A160M7 (20-22 mm) facing the pilot bearing side.
Substitution tool
-
Outer diameter: 21 mm {0.83 in}
-
Inner diameter: 19 mm {0.75 in}
2. As shown in the figure, press-fit the pilot bearing to the position which is 4.0-5.0 mm {0.16-0.19 in} from the crankshaft end.