3 L4-2.5L (2010)
Seals and Gaskets: Service and Repair
Oil Seal (Differential) Replacement [A26M-R]
OIL SEAL (DIFFERENTIAL) REPLACEMENT [A26M-R]
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Drain the oil from the transaxle. See: Service and Repair/Removal and Replacement/Transaxle Oil Replacement [A26M-R]
3. Remove the front tires. See: Steering and Suspension/Suspension/Service and Repair
4. Remove the splash shield. See: Body and Frame/Splash Guard/Service and Repair/Splash Shield Removal/Installation
5. Remove the aerodynamic under cover No.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
6. Separate the drive shaft and joint shaft from the transaxle. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Removal and Replacement/Drive Shaft Removal/Installation See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Removal and Replacement/Joint Shaft Removal/Installation
7. Remove the oil seals using a screwdriver.
8. Using the SSTs and a hammer, tap each new oil seal in evenly until the SSTs contact the transaxle case.
