323 L4-1600 1597cc (1986)
1.
Disconnect battery ground cable.
2.
Remove steering wheel, column cover and combination switch.
3.
Remove attaching screws and meter hood.
4.
Remove attaching screws, disconnect connectors and speedometer cable, and remove cluster.
5.
Remove attaching screws and side wall on both sides. Remove rear console. Remove front console by sliding it rearward. Disconnect antenna
cable.
6.
Remove fasteners and remove undercover on both sides.
7.
Remove screws and lower panel.
8.
Remove screws and remove lower louver and reinforcement. Remove hood release wire.
9.
Remove center and side hole covers and bolts.
10.
Remove side cover on both sides and remove bolts.
11.
Remove glove box and center bracket attaching bolts.
12.
Remove side bracket attaching bolt on both sides.
13.
Remove ashtray. Then remove screws and center panel. Disconnect cigarette lighter and remove bulb assembly.
14.
Remove heater control wires.
15.
Remove screws and lower cover.
16.
Remove instrument panel support bracket attaching bolts. Disconnect instrument panel connectors and remove instrument panel.
17.
Reverse procedure to install, using the following torque values:
^ Top Center Attaching Bolts: 3.1 - 4.6 ftlb
^ Lower Side Attaching Bolts: 5.8 - 8.0 ftlb
^ Remaining Attaching Bolts: 6.5 - 9.4 ftlb
