323 L4-1800cc 1.8L OHC (1991)
Transmission Position Switch/Sensor: Adjustments
Inhibitor Switch Adjustment
1.
Turn manual shaft to "N" position.
2.
Loosen switch mounting bolts.
3.
Align holes of inhibitor switch and manual shaft lever by inserting a pin of approximately 2.0 mm (0.079 in) OD.
4.
Torque mounting bolts to 8 - 11 Nm (69 - 95 inlb).
5.
Recheck continuity across connector terminals. Refer to COMPONENT TESTING. If not correct, replace switch.
6.
Install selector lever and torque to 44 - 64 Nm (33 - 47 ftlb).
