5 L4-2.3L (2007)
Sliding Door Window Glass: Service and Repair
Sliding Door Glass Removal/Installation
SLIDING DOOR GLASS REMOVAL/INSTALLATION
1. Fully open the sliding door glass.
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the side door garnish.
5. Remove the rear side trim.
6. Remove the sliding door trim.
7. Remove the bolt and screw.
8. Remove the rear door glass guide and glass run channel as a single unit.
9. Connect the power window subswitch connector.
10. Connect the negative battery cable.
11. Adjust the door glass position as shown in the figure.
