mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Front Drain Hose Removal/Installation|Page 7334 > < Front Drain Hose Removal/Installation|Page 7332
Page 1
background image

Sunroof / Moonroof Drain: Service and Repair
Rear Drain Hose Removal/Installation

REAR DRAIN HOSE REMOVAL

1. Remove the following parts:

1. A-pillar trim
2. Front scuff plate inner
3. Rear scuff plate
4. B-pillar lower trim
5. Front seat belt upper anchor installation bolt
6. B-pillar upper trim
7. Rear package tray lid
8. Sub-trunk
9. Third-row seat

10. Trunk end trim
11. Rear header trim
12. Third-row seat belt lower anchor installation bolt
13. Cargo compartment light
14. Trunk side trim
15. Second-row seat belt upper anchor installation bolt
16. C-pillar trim
17. Map light
18. Sunvisor
19. Assist handle
20. headliner

2. Disconnect the rear drain hose from the sunroof frame.
3. Remove the rear drain hose from the clips.
4. Pull the rear drain hose into the vehicle interior and remove the rear drain hose.

REAR DRAIN HOSE INSTALLATION

CAUTION:  If the rear drain hose is pinched or bent at any point, the water in the hose may not drain and could leak inside the vehicle. During
and after installation of the trims and headliner, always make sure there is no interference with the rear drain hose. Correct any abnormality if
found.

1. Apply soapy water to the part of the sunroof frame where the rear drain hose is inserted.
2. Insert the rear drain hose end into the sunroof frame.
3. Install the rear drain hose to the clips parallel to the pillar and free of looseness.
4. Insert the rear drain hose grommet into the hole of the inner rear pillar.
5. Install the following parts:

Front Drain Hose Removal/Installation|Page 7334 > < Front Drain Hose Removal/Installation|Page 7332