5 L4-2.3L (2007)
2. Measure the points indicated in the illustration using a caliper (micrometer).
3. Subtract the minimum value from the maximum, and if the result is not within the specification, machine the disc plate using a lathe.
Thickness variation limit
0.015 mm (0.00059 in)
Warning:
^
Do not exceed minimum disc plate thickness.
Disc Plate Thickness Inspection
Caution:
^
Excessive runout may result if the disc plate is removed from the vehicle then machined. Machine the disc plate while installed on the
vehicle.
1. Measure the thickness of the disc plate.
^
If the thickness is not within the specification, replace the disc plate.
Minimum front disc plate thickness
23 mm (0.91 in)
Minimum front disc plate thickness after machining using a brake lathe on-vehicle
23.8 mm (0.94 in)
