5 L4-2.3L (2007)
8. Move the engine mount rubber or engine until installation hole on the vehicle body aligns with hole in the engine mount bracket.
9. Lower the jack and tighten bolts on No.3 engine mount bracket.
Tightening torque: 55.0-77.3 ft-lbf (74.5-04.9 N.m)
NOTE:
^
Do not allow the engine mount bracket to be misaligned.
10. With engine supported as described in STEP 5, remove four (4) nuts and two (2) bolts from No.4 engine mount top plate. Remove top plate.
NOTE:
^
To access the mount, remove battery box.
11. Lift engine again using jack until No.4 engine mount is lifted slightly from vehicle body.
NOTE:
^
Do not raise engine too much or A/C pipe damage may occur.
12. With top plate of No.4 engine mount removed, move engine mount bottom plate or engine until all four (4) installation studs on the vehicle align
with the engine mount holes.
