5 L4-2.3L (2007)
Wheel Bearing: Service and Repair
WHEEL HUB, STEERING KNUCKLE REMOVAL/INSTALLATION
Caution: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring
harness If it Is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) and fix
the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, inspect the front wheel alignment and adjust it if necessary
Locknut Removal Note
