5 L4-2.3L (2007)
2. Set the SST parallel to the quick release connector.
NOTE:
-
The quick release connector can be removed by pushing the center of the retainer tabs.
-
The retainer is attached to the pipe even after the connector is disconnected.
3. Hold the center of the retainer tabs with the SST ends and press the retainer.
4. Pull the connector side and disconnect the quick release connector.
5. Raise a retainer tab using the SST and remove the retainer.
6. Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.
Type A Installation
NOTE:
-
If the quick release connector O-ring is damaged or has slipped. replace the fuel hose.
-
A checker tab is integrated with the quick release connector for new fuel hoses and evaporative hoses. Remove the checker tab from the
quick release connector after the connector is completely engaged with the fuel pipe.
1. Inspect the fuel hose and fuel pipe sealing surface for damage and deformation.
-
If there is any malfunction, replace it with a new one.
2. Apply a small amount of clean engine oil to the sealing surface of the fuel pipe.
3. Reconnect the fuel hose straight to the fuel pipe until a click is heard.
NOTE: If the quick release connector does not move at all, disconnect it, verify that the 0-ring is not damaged or has not slipped, and then
reconnect the quick release connector.
