5 L4-2.3L (2007)
Variable Induction Position Sensor: Testing and Inspection
VARIABLE TUMBLE SHUTTER VALVE SWITCH INSPECTION [L3]
Voltage Inspection
1. Turn the ignition switch to the ON position (Engine off).
2. Verify that the PCM terminal 2AE voltage is as shown in the following table when the variable tumble shutter valve actuator rod is depressed and
released by hand.
-
If not as specified, perform the "Circuit Open/Short Inspection".
-
If there is no open or short circuit, replace the intake manifold.
Variable tumble shutter valve switch output voltage
Circuit Open/Short Inspection
