5 L4-2.3L (2007)
Fluid Pressure Sensor/Switch: Testing and Inspection
OIL PRESSURE SWITCH INSPECTION (FN4A-EL)
Caution:
^
Water or foreign material entering the connector can cause poor connection or corrosion. Be sure not to drop water or foreign material
on the connector when disconnecting it.
On-vehicle Inspection (harness inspection)
1. Remove the battery duct and battery cover.
2. Disconnect the negative battery cable.
3. Remove the undercover.
4. Disconnect the cord assembly connector.
5. Verify that there is no continuity between the cord assembly terminal and ground.
^
If there is no continuity, inspect the cord assembly.
^
If the cord assembly is normal, inspect the oil pressure switch.
6. Connect the cord assembly connector.
7. Install the under cover.
8. Connect the negative battery cable.
9. Install the battery duct and battery cover.
On-vehicle Inspection (oil pressure switch inspection)
