5 L4-2.3L (2007)
6. Connect the SST (Deployment tool) to the SST (Adapter harness).
7. Connect the SST (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the
negative battery terminal.
8. Verify that the red lamp on the SST (Deployment tool) is illuminated.
9. Verify that all persons are standing at least 6 m (20 ft) away from the vehicle.
10. Press the activation switch on the SST (Deployment tool) to operate (deploy) the side air bag module.
11. Disconnect the SSTs (Deployment tool) from the SSTs (Adapter harness).
Curtain Air Bag Module
1. Remove the curtain air bag module.
2. Secure the curtain air bag module in a vise, and cut off the deployment section, as shown in the figure.
WARNING: Be sure not to crush the pipe on the side where it is cut. If it is crushed completely, the interior pressure of the pipe will
build up and can cause it to explode during air bag module operation (deployment).
