5 L4-2.3L (2007)
Transmission Position Switch/Sensor: Testing and Inspection
TRANSAXLE RANGE (TR) SWITCH INSPECTION (FN4A-EL)
Operating Inspection
1. Verify that the starter operates only when the ignition switch is turned to the START position with the selector lever in P or N position.
^
If there is any malfunction, adjust the TR switch.
2. Verify that the back-up lights illuminate when shifted to R position with the ignition switch at the ON position.
^
If there is any malfunction, adjust the TR switch.
3. Verify that the positions of the selector lever and the indicator are aligned. If there is any malfunction, adjust the TR switch.
Continuity Inspection
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign material
on the connector when disconnecting it.
1. Remove the battery duct and battery cover.
2. Disconnect the negative battery cable.
3. Remove the under cover.
4. Disconnect the TR switch connector.
5. Verify that the continuity is as indicated in the table.
