5 L4-2.3L (2007)
2. Using the SST, tighten the adjusting cover with a tightening torque of 20.0 Nm (2.0 kgf.m, 14.8 ft.lbf).
3. Using the SST, loosen the adjusting cover to 25-30°.
Locknut (on Adjusting Cover) Assembly Note
Caution:
^
Be sure that the adjusting cover will not turn together with the locknut.
1. Fix the adjusting cover and tighten the locknut.
2. Measure the pinion torque using the torque wrench.
Pinion shaft rotation torque
Center of rack ± 90°: 0.88-1.48 Nm (8.98-15.0 kgf.cm, 7.79-13.0 in.lbf)
3. If not as specified, remove the locknut and adjust the adjust cover.
Boot Assembly Note
1. Apply silicone grease to the rubber lip groove.
2. Assemble the boot.
Floor Seal Assembly Note
