5 L4-2.3L (2007)
NOTE:
^
Do not grind off too much of the arc-welding bead.
^
For best grinding results, use a 1/2 inch diameter carbide rotary file (or equivalent) at the proper tool RPM. This tool is locally sourced and
greatly reduces the grinding time.
5.
Apply touch up anti-rust paint to all exposed areas on the spring and crossmember.
6.
Install the right rear coil spring with a new spring seat rubber according to the instructions online on MS3 or the Workshop Manual section 06-12
REAR COIL SPRING REMOVAL/INSTALLATION.