5 L4-2.3L (2007)
Cross-Member: Service and Repair
Rear Suspension
REAR CROSSMEMBER REMOVAL/INSTALLATION
Caution: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit !in the wiring
harness If it is pulled by mistake. Before performing the following procedures, disconnect the ASS wheel-speed sensor wiring harness connector (axle
side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.
1. Remove the rear stabilizer.
2. Remove the charcoal canister.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Inspect the wheel alignment and adjust it if necessary.
Rear Crossmember Removal Note
Warning: Verify that the crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious Injury or
death, and damage to the vehicle.
