5 L4-2.3L (2007)
11.
Align and install the bolts for the right front stabilizer bracket, but do not tighten.
NOTE:
It may be necessary to lightly push or pull on the side of the stabilizer bar where it meets the stabilizer control links to allow clearance.
12.
Repeat steps 4-11 for the left front bushing, then tighten the bolts for both stabilizer brackets.
Tightening torque: 40.3 - 53.9 Nm (29.8 - 39.7 ft-lbf)
13.
Install the transverse member (if removed) and install the bolts.
Tightening torque: four larger bolts to 36.3 - 53.9 Nm (26.8 - 39.7 ft-lbf) and one smaller bolt to 7.8 - 10.8 Nm (70-95 in-lbf).
REAR STABILIZER BUSHINGS (FOR SQUEAK)
1.
Raise the vehicle in the air.
WARNING:
Before working on the vehicle, make sure the vehicle's engine and exhaust are cooled down.
NOTE:
Do one side at a time, otherwise the stabilizer bar could shift out of position and make the repair more difficult.
2.
Locate the rear stabilizer bar bushings.
3.
Remove the two bolts for the left rear stabilizer bracket.
4.
Remove the left rear stabilizer bracket.
