5 L4-2.3L (2007)
Suspension Spring ( Coil / Leaf ): Service and Repair
Front Suspension
Front Shock Absorber and Coil Spring Removal/Installation
FRONT SHOCK ABSORBER AND COIL SPRING REMOVAL/INSTALLATION
Caution: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring
harness If it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor wiring harness connector (axle
side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the front wheel alignment and adjust it if necessary.
Shock Absorber and Coil Spring Removal Note
1. Loosen the front lower arm inner bolt.
