5 L4-2.3L (2007)
2. Separate the shock absorber from the wheel hub, steering knuckle component by tapping the upper part of the steering knuckle with a hammer.
Shock Absorber and Coil Spring Installation Note
1. Install the shock absorber and coil spring so that the positioning projection on the mounting rubber is aligned with the positioning hole on the body
2. Align the knuckle notch with projection A on the lower side of the shock absorber.
3. Raise the front lower arm using a jack and install the shock absorber and coil spring.
Stiffener Installation Note
1. Install the stiffener so that the mark (RH or LH) faces upward.
Front Shock Absorber and Coil Spring Disassembly/Assembly
FRONT SHOCK ABSORBER AND COIL SPRING DISASSEMBLY/ASSEMBLY
Warning: Before removing the piston rod nut, secure the shock absorber and coil spring in the SSTs. Otherwise, the coil spring could fly off
under tremendous pressure and cause serious injury or death, or damage to vehicle parts.
1. Remove the front shock absorber and coil spring.
2. Disassemble in the order indicated in the table.
3. Assemble in the reverse order of removal.
