5 L4-2.3L (2007)
Pressure Regulating Solenoid: Testing and Inspection
SOLENOID VALVE INSPECTION (FN4A-EL)
Resistance Inspection (On-Vehicle Inspection)
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign material
on the connector when disconnecting it.
1. Remove the battery duct and battery cover.
2. Disconnect the negative battery cable.
3. Remove the undercover.
4. Disconnect the transaxle connector.
Note:
^
When inspecting the pressure control solenoid, connect the ground connection to the ground terminal (terminal 1) of the pressure control
solenoid inside the solenoid valve connector.
5. Measure the resistance between the following terminals.
^
If there is any malfunction, inspect the ground, then perform the operating inspection.
