5 L4-2.3L (2007)
Tightening torque
31.4-46.1 Nm (3.2-4.7 kgf.m, 23.2-33.9 ft.lbf)
18. Install the clip to the selector cable as shown in the figure.
19. Shift the selector [ever to P position.
20. Turn the manual shaft lever to P position.
21. Connect the selector cable.
22. Inspect for continuity at the TR switch. (See TRANSAXLE RANGE (TR) SWITCH INSPECTION (FN4A-EL).) See: Transmission Control
Systems/Testing and Inspection/Component Tests and General Diagnostics/Transaxle Range (TR) Switch Inspection (FN4A-EL)
^
If there is any malfunction, readjust the TR switch.
23. Connect the TR switch connector.
24. Install the under cover.
25. Connect the negative battery cable.
26. Install the battery duct and battery cover.
27. Inspect operation of the TR switch. (See TRANSAXLE RANGE (TR) SWITCH INSPECTION (FN4A-EL).) See: Transmission Control
Systems/Testing and Inspection/Component Tests and General Diagnostics/Transaxle Range (TR) Switch Inspection (FN4A-EL)
^
If there is any malfunction, readjust the TR switch.
