6 L4-2.5L (2010)
Keyless Entry Module: Service and Repair
Keyless Control Module Removal/Installation - Advanced Keyless Entry And Push Button Start
System
KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
1. If the keyless control module is replaced, always perform the following procedure.
-
Vehicles with immobilizer system
-
Keyless Control Module Configuration See: Testing and Inspection/Programming and Relearning/Keyless Control Module Configuration
-
Immobilizer System-related Parts Programming [No.4 Programming Procedure Due to Keyless Control Module Replacement] See:
Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Immobilizer
System-Related Parts Programming - Advanced Keyless Entry And Push Button Start System
-
Vehicles without immobilizer system
-
Keyless Control Module Configuration See: Testing and Inspection/Programming and Relearning/Keyless Control Module Configuration
-
Advanced Key Id Code Registration See: Testing and Inspection/Programming and Relearning/Advanced Key ID Code Registration
-
Steering Lock Unit Id Code Registration See: Testing and Inspection/Programming and Relearning/Steering Lock Unit ID Code
Registration
2. Disconnect the negative battery cable.
3. Remove the front scuff plate. See: Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate Removal/Installation
4. Remove the front side trim. See: Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim Removal/Installation
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.