6 L4-2.5L (2010)
18. Seat seal ring by lightly tapping end of special service tool (handle) with a rubber hammer.
19. Push in seal ring (A) until edge of it contacts flange (B).
20. Assemble converter to seal ring according to the Workshop Manual or MS3 online instructions (section 01-15A EXHAUST SYSTEM
REMOVAL/INSTALLATION [L5]).
NOTE:
Failure to follow the instructions may result in rattle noise due to misalignment of exhaust system.
21. Install springs, washers and hex nuts in order.
A - Exhaust Stud
B - Washer
C - Seal Ring
22. Verify repair.
WARNING:
Exhaust leaks can allow carbon monoxide into the vehicle and cause injury or death, please go over the system and be sure there are no gas
leaks at any point before returning the vehicle to the customer.