6 L4-2.5L (2010)
c. Start the engine and warm it up in the P position.
CAUTION:
-
If the oil level decreases dramatically while warming-up the engine, do not select the selector lever as it could damage the transaxle.
d. Remove the dipstick and wipe it clean while the engine is idling.
e. Install the dipstick and remove it again.
f.
Verify that the ATF level is in the range as shown in the figure.
-
If the ATF level is out of the range, adjust the ATF to the specification.
ATF type
-
Mazda Genuine ATF M-V
2. Inspect the ATF level after driving the vehicle.
a. Select the selector lever and pause momentarily in each position/range (from P position to D range) while depressing the brake pedal.
b. Drive on city roads at a minimum of 5 km {3 mile}.
c. Connect the M-MDS to the DLC-2.
d. Verify that the ATF temperature is 60-70 °C {140-158 °F} using the M-MDS.
e. Remove the dipstick and wipe it clean while the engine is idling.
f.
Verify that the ATF level is in the range as shown in the figure.
-
If the ATF level is out of the range, adjust the ATF to the specification.
ATF type
-
Mazda Genuine ATF M-V
