6 L4-2.5L (2010)
Engine Control Module: Removal and Replacement
PCM REMOVAL/INSTALLATION [L5]
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. When replacing the PCM on the vehicles, perform the following:
-
PCM configuration See: Testing and Inspection/Programming and Relearning
-
Immobilizer system component replacement/key addition and clearing See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Testing and Inspection/Programming and Relearning/Immobilizer System-Related Parts Programming - Keyless Entry System See:
Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Immobilizer
System-Related Parts Programming - Advanced Keyless Entry And Push Button Start System
