6 L4-2.5L (2010)
Engine Control Module: Recalls
Campaign MSP27 - ECM Update For OBD-II Readiness
Bulletin No: 01-054/09
Last Issued: 12/10/2009
Subject:
MAZDA SERVICE PROGRAM (MSP27) - READINESS CODE FOR EVAPORATIVE MONITORING SYSTEM
APPLICABLE MODEL(S)/VINS
DESCRIPTION
On certain 2010 CX-7 vehicles and 2009-2010 Mazda6 vehicles, a readiness status code, which is used for OBD-II Readiness Test, may be incorrectly
set due to improper programming of the evaporative monitoring system.
NOTE:
^ UNDER THE MAZDA SERVICE PROGRAM (MSP27), ALL CURRENT DEALER INVENTORY AND RETAILED VEHICLES FOUND TO BE
WITHIN THE ABOVE VIN AND PRODUCTION DATES RANGES MUST BE REPAIRED ACCORDING TO THE INSTRUCTIONS
CONTAINED IN THIS SERVICE BULLETIN.
^ BEFORE PERFORMING ANY REPAIR, VALIDATE THAT THE VEHICLE IS APPLICABLE TO THIS PROGRAM BY PERFORMING AN
"eMDCS WARRANTY VEHICLE INQUIRY" AND VERIFYING THE VEHICLE DISPLAYS CAMPAIGN "MSP27" AND ITS CAMPAIGN
STATUS DISPLAYS "OPEN". SEE "VEHICLE INSPECTION PROCEDURE" BELOW.
DEALER INVENTORY
Repair all applicable vehicles currently in dealer inventory according to the procedures contained in this service bulletin.
RETAIL VEHICLES:
When an applicable retail vehicle is brought into the dealer for any type of repair or scheduled maintenance, perform an eMDCS Warranty Vehicle
Inspection and check the status of MSP27. If status of MSP27 is "OPEN" repair the vehicle according to the procedures contained in this service
bulletin.
VEHICLE INSPECTION PROCEDURE
1. Verify the vehicle is within the following VIN and production date ranges:
2009-2010 Mazda6 2.5L vehicles produced from April 8, 2008 through October 30, 2009
^ VIN Range (2009 Mazda6): 1YVHP8***95M00057 - M52255
^ VIN Range (2010 Mazda6): 1YVHZ8***A5M00014 - M21961
2010 CX-7 2.5L vehicles produced from May 21, 2009 through October 21, 2009
^ VIN Range: JM3ER****A0300127 - 312034
-
If the vehicle is within the above VIN and production date ranges, proceed to Step 2.
-
If the vehicle is not within the above VIN and production date ranges, return the vehicle to the customer or inventory.
2. Perform a Warranty Vehicle Inquiry using your eMDCS System and inspect the vehicle for a Campaign Label MSP27 attached either to the vehicle's
bulkhead or to the vehicle's hood. Refer to eMDCS System - Warranty Vehicle Inquiry Results table below.
NOTE:
