6 L4-2.5L (2010)
Engine Control Module: Component Tests and General Diagnostics
PCM INSPECTION [L5]
Using M-MDS
NOTE:
-
PIDs for the following parts are not available on this model. Go to the appropriate part inspection.
-
CMP sensor
-
Main relay
1. Connect the M-MDS to the DLC-2.
2. Switch the ignition to ON.
3. Measure the PID value.
-
If PID value is not within the specification, follow the instructions in Action column.
NOTE:
-
The PID/DATA MONITOR function monitors the calculated value of the input/output signals in the PCM. Therefore, an output device
malfunction is not directly indicated as a malfunction of the monitored value for the output device. If a monitored value of an output device is
out of specification, inspect the monitored value of the input device related to the output control.
-
For input/output signals except those of the monitoring items, use a voltmeter to measure the PCM terminal voltage.
-
The simulation items that are used in the ENGINE CONTROL SYSTEM OPERATION INSPECTION are as follows.
-
ACCS, ALTF, ARPMDES, EVAPCP, EVAPCV, FAN_DUTY, FP, HTR11, HTR12, IMRC, IMTV, INJ_1~4, SEGRP, TEST, VT Duty1
wt
PID/DATA monitor table (reference)