6 L4-2.5L (2010)
-
If there is any malfunction, replace the input/turbine speed sensor. See: Service and Repair/Input/Turbine Speed Sensor Removal/Installation -
FS5A-EL
Input/turbine speed sensor specification
-
250-600 ohms
Intermediate Sensor Inspection - FS5A-EL
INTERMEDIATE SENSOR INSPECTION [FS5A-EL]
CAUTION:
-
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
-
Do not damage the terminals.
On-Vehicle Inspection
1. Inspect the power supply circuit for the intermediate sensor.
a. Set the battery and battery tray out of the way.
b. Disconnect the intermediate sensor connector.
c. Switch the ignition to ON (engine off).
d. Measure the voltage at intermediate sensor connector terminal A (harness-side).
-
If there is any malfunction, repair wiring harness between intermediate sensor and TCM.
Intermediate sensor specification
-
4.5-5.5 V
e. Switch the ignition to off.
f.
Connect the intermediate sensor connector.
2. Inspect the GND circuit for the intermediate sensor.
