6 L4-2.5L (2010)
2. Measure the current while waving a magnet back and forth over the top of the VSS (less than 5 mm {0.197 in}).
-
If there is any malfunction, replace the VSS. See: Sensors and Switches - Powertrain Management/Sensors and Switches - Computers and
Control Systems/Vehicle Speed Sensor/Service and Repair/Vehicle Speed Sensor (VSS) Removal/Installation - AW6A-EL
VSS specification
Vehicle Speed Sensor (VSS) Inspection - FS5A-EL
VEHICLE SPEED SENSOR (VSS) INSPECTION [FS5A-EL]
CAUTION:
-
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
-
Do not damage the terminals.
On-Vehicle Inspection
1. Inspect the power supply circuit for the VSS.
a. Remove the aerodynamic under cover NO.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
b. Disconnect the VSS connector.
