6 L4-2.5L (2010)
Relay Box: Testing and Inspection
Relay Block Inspection - With Advanced Keyless Entry And Push Button Start System
RELAY BLOCK INSPECTION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
1. Disconnect the negative battery cable.
2. Remove the lower panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Lower Panel Removal/Installation
3. Remove the knee bolster. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Knee Bolster Removal/Installation
4. Remove the relay block. See: Service and Repair
5. Verify that the continuity is as indicated in the table.
-
If not as indicated in the table, replace the relay block.
