6 L4-2.5L (2010)
Keyless Starting System: Initial Inspection and Diagnostic Overview
Foreword - Advanced Keyless Entry And Push Button Start System
FOREWORD [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
-
The OBD (on-board diagnostic) system has the following functions:
-
Malfunction detection function: Detects malfunctions in the advanced keyless entry and push button start system and outputs DTCs.
-
PID/data monitor function: Reads out specific input/output signals and the system status.
-
Diagnostic DTCs can be read/cleared using the M-MDS.
Foreword - Immobilizer System (Advanced Keyless Entry And Push Button Start System)
FOREWORD [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)]
-
DTCs are recorded in the PCM and keyless control module when a malfunction is detected. The stored DTCs can be verified using the flashing
pattern of the security light and M-MDS. There are some DTCs which cannot be verified using the security light. Verify the DTCs that were
detected using the M-MDS prior to beginning the servicing.
See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Inspection - Immobilizer System (Advanced Keyless Entry And Push Button Start System)
-
If more than one DTC is detected, the security light only displays the DTC with the lowest number. Begin repairs based on the DTC displayed by
the security light. All DTCs can be read by the M-MDS.
-
It is possible for several DTCs to be displayed for a one malfunction cause. Erase the DTCs after one repair and then re-inspect the DTCs.
-
If immobilizer system DTCs are not recorded even if the engine cannot be started, perform symptom troubleshooting.
See: Engine, Cooling and Exhaust/Engine/Testing and Inspection/Symptom Related Diagnostic Procedures/No.3 Will Not Crank
See: Engine, Cooling and Exhaust/Engine/Testing and Inspection/Symptom Related Diagnostic Procedures/No.3 Will Not Crank
-
The PID/data monitor function can be used to verify the number of key ID numbers programmed for a single vehicle.
See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Pinout Values and Diagnostic
Parameters/PID/Data Monitor Table/Immobilizer System (Advanced Keyless Entry And Push Button Start System)
NOTE:
-
Due to the possibility that the engine cannot be started because transmission between the key and the vehicle is obstructed, do not allow the
following items to contact the key ring.
-
Any metallic object
-
Spare keys or keys for other vehicles equipped with an immobilizer system
-
Any electronic device, or any credit or other card with magnetic strips
