6 L4-2.5L (2010)
CAUTION:
-
If a tool is installed to the SST (49 E032 308), install the tool so that it is perpendicular to the SST as shown in the figure. If the tool is not
installed as instructed, the SST can separate from the tie rod easily which could cause damage to the tie rod while doing the work.
3. Remove the tie-rod lock washer.
Locknut (adjusting cover), Adjusting Cover Disassembly Note
1. Remove the locknut (adjusting cover) from the gear housing using the SST.
CAUTION:
-
If a tool is installed to the SST (49 E032 308), install the tool so that it is perpendicular to the SST as shown in the figure. If the tool is not
installed as instructed, the SST can separate from the locknut easily which could cause damage to the locknut while doing the work.
2. Remove the adjusting cover from the gear housing.
Pinion Shaft Component Disassembly Note
1. Remove the pinion shaft component from the valve housing using a press and steel plate.
Seal Ring Disassembly Note
