6 L4-2.5L (2010)
Fluid - A/T: Procedures
Automatic Transaxle Fluid (ATF) Inspection - AW6A-EL
AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [AW6A-EL]
Automatic Transaxle Fluid (ATF) Condition Inspection
1. Inspect the ATF for the following to determine whether the transaxle should be disassembled.
-
The ATF is muddy.
-
The ATF smells strange or unusual.
Automatic Transaxle Fluid (ATF) Level Inspection
CAUTION:
-
The ATF amount varies according to ATF temperature. Therefore, when checking the ATF level or replacing the ATF, use a thermometer to
measure the temperature and adjust the ATF amount to the specified level according to the specified temperature.
1. Place the vehicle on level ground.
2. Apply the parking brake and position wheel chocks securely to prevent the vehicle from rolling.
3. Connect the M-MDS to the DLC-2.
4. Monitor the ATF temperature using the M-MDS.
5. Warm up the transaxle until the ATF reaches 60-70 °C {140-158 °F}.
6. Select the selector lever and pause momentarily in each range (P-D) while depressing the brake pedal.
7. Select the selector lever to P position.
