6 L4-2.5L (2010)
Clutch Disc: Testing and Inspection
CLUTCH DISC INSPECTION
1. Refer to CLUTCH UNIT REMOVAL/INSTALLATION to remove the clutch disc. See: Service and Repair
2. Using vernier calipers, measure the thickness of the lining at a rivet head on both sides.
-
If it less than the minimum specification, replace the clutch disc. See: Service and Repair
Minimum clutch disc thickness
-
0.3 mm {0.01 in}
3. Measure the clutch disc runout using a dial indicator.
-
If it exceeds the maximum specification, replace the clutch disc. See: Service and Repair
Maximum clutch disc runout
-
0.7 mm {0.03 in}