6 L4-2.5L (2010)
Clutch Pedal Position Sensor / Switch: Testing and Inspection
CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [L5]
Continuity Inspection
1. Verify that the CPP switch is installed properly.
2. Disconnect the negative battery cable.
3. Disconnect CPP switch connector. See: Clutch Pedal Assembly/Service and Repair
4. Inspect for continuity between the CPP switch terminals using an ohmmeter.
-
If not as specified, replace the CPP switch. See: Clutch Pedal Assembly/Service and Repair
Specification
