6 L4-2.5L (2010)
11. Install the TCM.
12. Verify the correct positioning of the TCM and coupler component.
13. Tighten the TCM mounting bolts.
Tightening torque
-
20-29 Nm {2.1-2.9 kgf-m, 15-21 ft-lbf}
14. Install the manual shaft lever and the washer.
15. Set the adjustable wrench as shown in the figure to hold the manual shaft lever.
CAUTION:
-
Do not use an impact wrench. Hold the manual shaft lever when installing the manual shaft nut, or the transaxle may be damaged.
16. Tighten the manual shaft nut.
Tightening torque
-
10-14 Nm {102-142 kgf-cm, 89-123 in-lbf}
17. Install the clip to the selector cable as shown in the figure.
