6 V6-3.0L DOHC (2003)
Brake Master Cylinder: Service and Repair
Removal and Installation
MASTER CYLINDER REMOVAL/INSTALLATION
1. Remove the battery and battery tray.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Master Cylinder Installation Note
Caution:
^
If the master cylinder is installed at a slanted angle to the power brake unit, the master cylinder piston may jam against the push rod retainer of the
power brake unit, causing improper air bleeding, brake drag or other malfunctions. Be sure to install the master cylinder at a level, perpendicular
to the power brake unit.
^
Always install the gasket of the power brake unit push rod before performing measurement inspections or adjustments.
1. Install the SST to the power brake unit as shown, and tighten within the specified torque.
Tightening torque - 9.8 - 16.0 Nm (100 - 163 kgf-cm, 87 - 141 ft. lbs.)
