6 V6-3.0L DOHC (2003)
2.
Remove the cap and filter from the brake reservoir tank.
3.
Place cap and filter on a clean shop towel.
4.
Turn the IG key to ON position.
5.
Release parking brake lever.
6.
Confirm status of "Brake" warning light in instrument panel.
^
If the brake warning light is illuminated with the parking brake released, you must first fix any problems with the parking brake warning
system (Refer to Parking Brake System, Section 04-12 of the 2003 Mazda6 Workshop Manual).
^
If the brake warning light goes off when you release the paring brake, go to Step 7.
7.
Wipe SST (4900-M6-TL0) with clean shop towel.
8.
Insert SST (hook side down) approx. 2" into brake reservoir tank opening through center slot (as shown).
9.
Gently push the SST downward until the float bottoms out (total float travel is approx. 1"). Leave the float in the bottomed-out position.
10.
Confirm status of "Brake" warning light in instrument panel.
^
If warning light is illuminated, move SST upward and ensure the float moves smoothly upward, go to Step 5 of "C. CORRECTION
PROCEDURE".
