6 V6-3.0L DOHC (2003)
Caution:
-
Install the camshaft journal thrust caps last, or damage to the thrust caps may occur.
5. Tighten the bearing caps evenly in several passes in the order shown.
Note:
-
After adjusting the camshaft end play using the thrust caps 1 R and 5R, tighten the other bearing caps.
Chain Tensioner (RH) Installation Note
1. Set the chain tensioner (RH) in a vise with jaw protectors.
2. Using a thin screwdriver, hold the chain tensioner (RH) ratchet lock mechanism away from the ratchet stem.
Note:
-
The piston should retract with minimal force. If binding occurs, remove the tensioner from the vise and reset it in the vise.
3. Slowly compress the tensioner piston.
4. Hold the tensioner piston using a 1.5 mm (0.059 inch) wire or paper clip.
