6 V6-3.0L DOHC (2003)
Caution:
^
Improper adjustment of the TR switch will cause abnormal operation of the automatic transaxle. Be sure to use the SST to adjust the TR switch
correctly.
11. Using the SST and by turning the TR switch, adjust the positions of the manual shaft and the TR switch neutral hole.
12. Tighten the TR switch mounting bolts.
Tightening torque 4.9 - 6.9 Nm (50 - 70 kgf-cm, 44 - 61 inch lbs.)
13. Inspect for continuity at the TR switch between terminals C and D.
14. Remove the SST.
15. Install the manual shaft lever and washer.
Caution:
^
Do not use an impact wrench. Hold the manual shaft lever when tightening the manual shaft nut, or the transaxle may be damaged.
16. Set the adjustable wrench as shown to hold the manual shaft lever.
17. Tighten the manual shaft nut using a torque wrench.
Tightening torque 31.36 - 6.06 Nm (3.2 - 0.6 kgf-cm, 23.2 - 33.9 ft. lbs.)
18. Install the clip as shown in the figure.
^
If it is bent, replace a new clip.
